Steele Products SP-CT11 - Manual (Page 6)

6
Air Tank
OPERATION
TO FILL
• Fill air tank only at a service station or use a low pressure air compressor (0 – 100 psi).
• Press air compressor chuck against the intake valve until the tank is filled.
• Fill air tank pressure to between 75 and 125 psi only. Pressure gauge indicates the
level of air pressure inside the tank.
• Do not overfill. Tank pressure must not exceed 125 psi.
TO USE
• To open, turn the red intake valve control wheel counterclockwise to allow air to flow
from the tank through hose.
• Press the chuck onto tire’s valve stem.
• To close, turn the intake valve control wheel clockwise to stop air from flowing through
the hose.
TO RELEASE PRESSURE:
• Pull on the safety valve attached to the automatic bypass valve.
• When the tank is empty, the pressure gauge will register zero.
CAUTION!
• Do not overfill.Tank pressure
must not exceed 125 psi.
• The built-in pressure gauge
will provide an estimated
reading only.
• The built-in pressure gauge
cannot use to measure tire
pressure.
• Keep out of reach of children.
TO CONTROL AIR FLOW
Open
Close
Release Pressure