Steele Products SP-PT221 - Manual (Page 6)

5
Operation
Sanding
A) Secure work-piece and make sure that the sandpaper is firmly
installed.
B) With the sander not in contract with the work-piece, switch the tool
to the ON-position
C) Carefully move the mouse sander to the work-piece and begin
sanding operation.
WARNING: DO NOT SAND ANY AREA TOO HEAVILY OR FOR MORE
THAN A FEW SECONDS AT A TIME. APPLY EVEN PRESSURE IN A
RANDOM PATTERN OVER THE ENTIRE SURFACE.
D) To sand down profiles and grooves, use the point or the plastic base.
E) Check wearing condition of the sandpaper after a few minutes of
work, replace if necessary.
WARNING: DO NOT USE TORN OR SEVERELY WORN SANDPAPER
YOU MAY DAMAGE YOUR WORK SURFACE OR SUFFER PHYSICAL
INJURY.
After Operation
WARNING: ALWAYS REMOVE THE SANDER FROM THE WORK
SURFACE BEFORE TURNING OFF THE TOOL!
Maintenance
WARNING: Always UNPLUG the tool before performing any service or
maintenance.
1. Dust the tool after work.
A) Clean the tool off excess work-dust and debris regularly.
B) Clean the tool handle and keep it free from oil and grease.
Technical Data
Power Source: 120VAC 60Hz. 0.8 A
Single Speed: 10,000 OPM