Steele Products SP-PT235 - Manual (Page 7)

OWNER’S MANUAL
6
Figure 1
Variable Speed Trigger (Fig. 2)
1. To start the drill, pull the trigger (1). Rotational speed will
increase as the trigger is depressed. To stop, release the trigger.
2 . For continuous operation, pull the trigger (1) and depress
the lock-on button (2). The drill will continue to run until
the trigger is pulled fully and then released.
Caution:
Figure 2
Do not move the forward and reverse lever while drill 1. On / Off Switch
is in use, damage to tool could result. Allow tool to 2. Lock-on button
come to a complete stop before changing direction . 3. Forward / Reverse
Lever
•Always check tool rotation direction before drilling.
3. Use the forward and reverse lever (3) to select direction.
Push it to the "left" position for clockwise rotation and
"right" position for counter clockwise rotation.
Installing / Changing Bits (Fig.3)
WARNING
:RISK OF PERSONAL INJURY. ALWAYS DISCONNECT
TOOL FROM POWER SOURCE BEFORE MAKING ANY
ADJUSTMENT, INSTALLING OR CHANGING DRILL BITS.
1. Rotate ring (1) counter clockwise to open chuck fully.
2. Insert drill bit into chuck as far as it will go.
3. Rotate ring (1) clockwise to tighten chuck fully Figure 3
4. Drill is ready for use.
WARNING: Let the drill operate for one minute without load before beginning
to drill.
Caution:
Always use clamps to secure the work piece when drilling. Maximum torque often
occurs at the point the bit breaks through the work piece. Grasp the tool firmly and
proceed slowly as this occurs
.
Drilling/driving
1. Drilling in different materials:
 Wood - Hold the drill firmly and place the point of the bit in the center of the desired
hole location. Depress the trigger to start drilling.
 Metal - Use a punch to mark hole position. Place the point of the bit in the center of
punch mark. Depress the trigger to start drilling. Use cutting oil in most metals to