Steele Products SP-HD905 - Manual (Page 5)

5
Owner’s Manual
NOTE: Do not force knob beyond its normal stop position. It may be necessary to make
minor adjustments to the thermostat to maintain the desired comfort level. Clockwise
movement will increase the room temperature. Counter-clockwise movement will
decrease room temperature.
5. To conserve energy, the heater may be operated at a lower wattage by rotating
control knob to the “1300 W” position.
6. When heater is not needed, rotate control knob to the “OFF” position, remove the plug
from outlet, and move heater to safe place for storage.
IMPORTANT NOTE
Do not expect the heating coils on your heater to glow. Coil elements are normally dark.
Air movement over these coils prevents glowing yet provides warm air, similar to a
forced-air-furnace. Some glow may occur where the moving air does not directly touch
the coils.
CLEANING AND STORAGE
Turn selector switch “OFF”, then remove plug from electrical outlet before cleaning
heater. Use a soft cloth for dusting. For cleaning use only a damp rag and non-abrasive
dish detergent. Do not use abrasive or chemical cleaners as these may harm finish. If
heater is used in a very dusty location, use a vacuum cleaner dust brush to remove dust
and other foreign material from grilles. Always unplug cord and wrap around heater
when not in use. Move heater to a safe location for storage.
SERVICE
This heater does not require any routine maintenance other than occasional cleaning
to prevent clogging of intake grille openings. To clean air intake grille, us vacuum with
brush attachment or high pressure air. The motor is permanently lubricated. Do not
operate the heater with a damaged cord or plug or if the heater malfunctions or has
been damaged in any manner.