Steele Products SP-HD907 - Manual (Page 4)

4
Owner’s Manual
Heater Switch Functions
Functions are selected by turning rotary switch to the desired position.
Provides 1500 watts of heat output
Provides 750 watts of heat output operation.
Fan only operation for cooling comfort.
Will power the unit off.
SAVE THESE IMPORTANT INSTRUCTIONS FOR EASY REFERENCE.
Electrical Ratings
This product is rated 12.5 amps (1500W) at 120V, 60Hz.
Operation
• Place the heater on a firm, level surface free from obstructions, and at least 3ft.
(0.9m) away from any wall or combustible material.
• With the selection switch in the position, plug the heater into a polarized
120V outlet.
• Turn the thermostat control fully clockwise to the max setting.
• To turn the heater on, selection switch while turning it clockwise to the desired
position ( for 1500W, or for 750W). The power light will illuminate.
• When the room reaches a comfortable temperature, slowly turn the thermostat
control counter-clockwise until the heater goes off. This is the point at which the
thermostat setting equals the room temperature. At this setting, the thermostat will
automatically turn the heater on and off to maintain this selected temperature.
• Turn the selection switch to and unplug the heater when you are finished using it.
If Your Heater Fails To Operate:
• Be sure it is plugged in and that the electrical outlet is working.
• Check for any obstruction. If you find an obstruction turn the heater unplug the
heater and wait at least ten minutes for it to cool. Carefully remove the plug from the
socket and have the appliance serviced by authorized service personnel only.
• Check that the thermostat is not set too low. With the selection switch set a heat
setting, turn the thermostat up (clockwise) until the heater restarts.