Steele Products SP-HI1500R - Manual (Page 4)

(C1) POWER ON/OFF
(C2) INCREASE +
(C3) CLOCK/TIMER SET
(C4) TIMER DELETE
(C5) TIMER SELECT
(C6) DECREASE
–
SET DESIRED TEMPERATURE
To set the desired temperature that you want the heater to maintain, simply press the +
(D3) or the
–(D5)button to move the desired set temp up or down. If using the
REMOTE, simply press the (C2) or the (C6) to set the temp. After a few seconds the set
temp display will stop flashing and the heating elements will be turned on. In about one
minute, the fan will be on to delivery warmed air from front vent.
Note: After setting the desired temperature & the displayed digit stops flashing. The
actual room air temperature will be displayed. To check set temperature at any time by
simply press the + or
– button on the control panel or remote control.
Once the room temperature reaches the desired setting, the thermostat will maintain
your desired comfort setting by turning the heating elements on and off automatically.
If you do not need the heater to run, simply press the power on/off button (D1 or C1 on
remote) to turn it off.
The fan will continue to run until the heating elements inside cools down.
The heater is equipped with an internal safety switch that cuts off power to the infrared
heating tubes if airflow is blocked to the unit. To restore power to the heating tubes,
remove power cord from wall outlet and let the unit cool down for approximately 20
minutes before plugging power cord back into the wall outlet. Then perform previous
power on procedures. If the heater has cooled sufficiently the safety switch will
automatically reset and the heating tubes will begin to work again.