Steele Products SP-HO76 - Manual (Page 6)

require the heater to be off, push the button “hour” and “minute” until your required operating time appears.
The operating time has a span of 24 hours. Auto on and auto off default value is “00:00”.
c) Auto
Press the button “booking timer” until the LCD appears “AUTO”. This indicates that the auto mode comes
into effect. The timing pilot lamp (yellow lamp) now lights up.
During operating in the auto mode, you can use the button “+”or “-“to set the desired comfort temperature as
described above and the appliance will automatically switch on or off at the preset time and automatically
maintain the preset comfort temperature.
NOTE: Do not press the button “power setting” when operating in the auto mode, this will cancel the function
of “booking timer”.
To cancel the function of “booking timer”, press the button “booking timer” until blank appears and wait for 5
seconds or press the button “power setting” , the timing pilot lamp (yellow lamp) will be extinguished.
NOTE: To keep the heater’s memory programmed, always leave the heater plugged in at the mains socket.
If the heater looses its electricity supply, e.g. switched off at the mains socket or in the event of a power
failure, the heater’s programs will be lost, and the heater will not work until reset.
This heater includes an overheat protection system that shuts off the heater when parts of the heater are
getting excessively hot. Once it occurs, the heater’s programs will be lost.
To completely shut the heater off, set the button “power setting” to OFF, then remove plug from the
socket-outlet.
POWER SUPPLY CORD
Plug the power supply cord into a wall outlet (120V AC 60Hz).
This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the
plug fully into the outlet, try reversing the plug.
MAINTENANCE
1. Always remove the plug from the power socket and allow the radiator to cool down. Wipe radiator with a
soft damp (not wet) cloth. Do not use detergents and abrasives. Do not allow the interior to get wet as
this could create a hazard.
2. To store away the heater, wind the cable around the cord bobbin, and store in a clean dry place.
3.
This appliance has been built to give many years of trouble-free service. In case of malfunction of doubt,
do not try to repair the radiator yourself; it may results in a fire hazard of electric shock. Call the nearest
Service Center.
6
Owner’s Manual