Steele Products SP-PM200M - Manual (Page 2)

SAFETY RULES SAFETY RULES IMPO
R
TANT! Some of the following symbols may appear on
this tool. Study them carefully and learn their meaning. Proper interpretation of these symbols will allow for better and safer operation of the tool. • Never place hands, fingers, or feet inside the reel. Although this mower is not powered by a motor, the reel spins when the wheels turn, and it is sharp enough to cause serious injury. • Never mow the grass when it is wet enough to be slippery. • Do not use the reel mower while barefoot or while wearing sandals. • Walk slowly. Do not run. Always make sure of your footing when using the reel mower. • Do not intentionally strike or ram trees, fences, etc. Doing so may cause injury or may severely damage the reel mower mechanisms. • Verify that the reel mower is in proper operating condition. Do not attempt to operate the reel mower if it is damaged. Have it repaired before using.
- 3 -
ASSEMBLY ASSEMBLING THE HANDLE 1.
T
op handle
2. Center handle pieces 3. Left lower handle 4. Right lower handle 5. Foam grip 6. Long bolts 7. Flat washer 8. C-clip 9. Knob
Fig 1
1
2
3
6
6
6
9
9
7
8
14
4
Tools Required Pliers (Not included) ASSEMBLY INSTRUCTIONS
Refer to Fig 1.
This product normally requires 6 to 10 minutes for assembly. NOTE: Do not tighten the bolts completely until all bolts have been inserted through the holes in the handle pieces. 1. Insert the 2 center handle pieces into the left and right sides of the top handle, and secure them in place using screws. 2. Connect the right lower handle to the left lower handle, and secure using two 1 3/8” long bolts and hex nuts (provided). 3. Attach the top handle assembly to the lower handle assembly using four 1 3/8” long bolts and hex nuts (provided). 4. Tighten all of the hex nuts on the joints of the handle assembly.
- 4 -