AKiTiO NT2 U3 - Manual (Page 2)

NT2 U3 Introduction
[1]
1 Introduction
1.1 System Requirements
1.1.1 PC Requirements
• Minimum Intel Pentium III CPU 500MHz, 128MB RAM
• Windows Vista, Windows 7
• Your hardware device must have the correct corresponding port (e.g. USB 3.0 host controller)
1.1.2 Mac Requirements
• Minimum Apple G4 processor, 128MB RAM
• Mac OS 10.4 or above
• Your hardware device must have the correct corresponding port (e.g. USB 2.0 host controller)
Note
USB 3.0 is not available for the Mac except with a special PCI card that comes with a USB 3.0
driver for Mac OS. However, it is possible to use the drive with the slower USB 2.0 connection.
1.1.3 Supported Hard Drives
• One or two 3.5" SATA-I, SATA-II or SATA-III hard drives
• 80GB - 3TB per HDD
• Hard drives of identical capacities are recommended
• Supports large volumes in excess of 2TB
Note
In order for the computer to access volumes larger than 2TB, both the hardware and OS need
to have the capacity to support large volumes (e.g. Windows 7 or Mac OS 10.4 and above).
1.2 Package Contents
Package content may vary depending on vendor & version.
•
NT2 storage enclosure (hard drives not included)
• Power supply
• Interface cable
• User manual
1.3 About this Manual
Firmware, images and descriptions may vary slightly between this manual and the actual product
you have. Functions and features may change depending on the firmware version.
1.4 Trademarks
• MS-DOS, Microsoft, Windows Vista & 7 are trademarks of Microsoft Corporation.
• Apple Macintosh and Mac are trademarks of Apple Computer.
• All other third party brands and names are the property of their respective owners.