L.B. White Torchman 500 w/ Optional Handle - Manual (Page 8)

TORCH ASSEMBLY
(See Fig. 1)
8
TO PROP
ANE GAS SUPPL
Y
(FLOW ARROW ON VALVE
BODY IN DIRECTION
OF GAS FLOW)
TO PROP
ANE GAS
SUPPL
Y
FOR MODEL 172-D
ASSEMBLE POL TO HOSE
T500-P02-2
HANDLE
MANUAL VALVE
HOSE ADAPTER
(1/4 MALE NPT X
MALE 9/16 - 18 LHT)
GAS HOSE
(WITH LEFT HAND THREAD NUTS)
FOR MODEL 161-D
ASSEMBLE REGULATOR
TO HOSE
HOSE
POL NUT
AND STEM
HEAD
(CAST OR STEEL)
■
Use only the L.B. White regulator supplied with the
torch.
■
The model 16 1-D torch must be regulated at all times
for proper operation.
■
The regulator must be installed so its vent is directed
downward.
■
Regardless of torch model, leak check all connections
whenever the torch is connected to the gas supply.
1. Both torches are supplied with a male nut and stem
called a POL. Remove the cap from the POL. Insert
POL stem into the valve on the propane gas supply.
Thread the nut counterclockwise into the propane
supply valve. Tighten the nut securely with a wrench.
See Fig. 4.
2. Slowly open the tank valve. This will prevent lock-up
of the excess flow valve within POL stem.
3. Check all connections with approved leak detector.
Do not use flame to check for leaks. A fire or
explosion may result.
4. When storing or transporting the torch, ensure the
POL is protected from damage and dirt entry.
FIG. 4
CONNECTING THE TORCH TO THE PROPANE GAS SUPPLY
POL NUT
AND STEM
1. Slide handle onto torch. Turn handle clockwise to
tighten at desired position.
2. Assemble other components as shown. Use pipe
thread compound. Ensure all connections are
tightened securely.
3. Connect to the propane gas supply.
FIG. 1