Rubicon Express RE7143 - Manual

RE7123B Page 1 of 6
RUBICON MANUFACTURING INC. 3290 MONIER CIR., RANCHO CORDOVA, CA. 95742 916-473-4600
INSTALLATION INSTRUCTIONS FOR:
RE7123 2 DOOR JK WRANGLER
RE7143 4 DOOR JK WRANGLER
SUPER-FLEX SHORT ARM SUSPENSION SYSTEM
Application Notes:
1) The transmission skid plate must be removed and will not be reinstalled due to drive shaft clearance.
2) It may be necessary that a front CV drive shaft be used in conjunction with this lift on either 2 or 4 door models. 2 Door models
may also require a CV rear drive shaft.
Safety Warning:
Suspension systems or components that enhance the off-road performance of your vehicle may cause it to handle differently, on and off-road, than it did
from the factory. Care must be taken to prevent loss of control or vehicle rollover during sudden maneuvers. Failure to drive the vehicle safely may result
in serious injury or death to driver and passengers. We recommend you always wear your seat belt, drive safely and avoid quick turns and other sudden
maneuvers. Constant maintenance is required to keep your vehicle safe. Thoroughly inspect your vehicle before and after every off-road use.
Installation Warning:
All procedures described in these instructions were performed while the vehicle was properly supported on a vehicle lift. Use caution when
supporting the vehicle as removing and installing parts will change the vehicle center weight. Rubicon Express recommends that chassis support
jacks are always used at the front and rear of the vehicle during the installation of a suspension system.
We recommend that certified technicians perform the installations of our products. Attempts to install these products without knowledge or experience
may jeopardize the safety of the vehicle. These instructions only cover the installation of our products and may not include factory procedures for
disassembly and reassembly of factory components. Read instructions from start to finish and be sure all parts are present before disassembling the
vehicle. Included instructions are guidelines only for recommended procedures and in no way are meant to be definitive. Installer is responsible to insure a
safe and controllable vehicle after performing modifications. Do not perform test drives on public roads with partially completed installations. Always
double and triple check your work before use.
ESP WARNING NOTE: The new 2007 Jeep Wrangler JK is equipped an Electric Stability Program (ESP). This system is designed to help
control the vehicle in times of uncertain traction conditions and roll stability. Due to the complex nature of this program Rubicon Express
strongly suggest that after lifting the vehicle it is returned to the dealer for a computer “flash” to re address tire size and proper ESP control
settings. Rubicon Express also recommends that you become familiar with the ESP controls and how the different level of settings can help you to
keep better control of your vehicle.
KIT CONTENTS
RE1143 Gen2 Sway Bar Disconnects
RE1157 Rear Sway Bar End Links
RE1370 (2 Door) RE1371 (4 Door) Front 3.5” Coil Springs
RE1375 (2 Door) RE1376 (4 Door) Rear 3.5” Coil Springs
RE1380 2” Front lower bump stops
RE1387 Rear bump stop pad
RE1530 Front SS brake line set
RE1540 Rear SS brake line set
RE1607 Rear Lower Track Bar Bracket
RE1673 Front Adjustable Track Bar
RE3750 JK Super-Flex Front Lower fixed arms
RE3752 JK Super-Flex Front Upper Adjustable arms
RE3755 JK Super-Flex Rear Lower fixed arms
RE3757 JK Super-Flex Rear Upper Adjustable arms
TYPICAL TOOLS REQUIRED
Basic mechanics hand tools. Optional floor jack, jack stands, wheel chocks for ground installation.
INSTALLATION OVERVIEW
The installation process can be broken down into the following tasks:
1. Installation of front control arms, track bar and bracket, coil springs and bump stops, shocks, and brake lines, Sway bar
disconnects.