Rubicon Express RE9905 - Manual (Page 2)

member. Separate right and left brackets with the four-hole
section, that mates to the drop bracket, toward the center of the
vehicle. One bolt on either side of the cross member is a stud.
This will have to be removed and replace with a hex head bolt
(supplied in transfer case drop kit of main XJ kit). Remember to
support transmission before removing bolts at cross member.
17. Verify that the brace will align with the 4 punched holes in the
drop brackets on either side. If not, adjust accordingly. Make
certain brace is bolted through the factory mount to the new
control arm drop brackets at the top two holes. The bottom two
bolt right to the drop brackets.
PHOTO 1
PHOTO 2
PHOTO 3
RE9900-9905A Page 2 of 2