Poison Spyder ROCKBRAWLER HI-LIFT JACK MOUNT - Manual

INSTALLATION INSTRUC
TIO
NS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
ROCKBRAWLER HI-LIFT JACK MOUNT
The Poison Spyder Customs RockBrawler Hi-
Lift Jack Mount is designed to easily mount a Hi-
Lift jack to the spare tire rack on a Poison Spyder
RockBrawler Rear Bumper. It is easy to install
with the right tools and good mechanical abilities.
If you are not confident in your mechanical skills,
please seek the help of a professional to perform
the installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
(1) RockBrawler Hi-Lift Jack Mount Plate
(4) Urethane Bushing
(2) 1/2-13 X 3” Carriage Bolt
(2) 1/2” Pushnut Bolt Retainer
(2) 1/2-13 Wing Nut
(2) 1/2-13 Nylon Insert Lock Nut
(4) 3/8-16 X 1” Gr8 Hex Head Cap Screw
(4) 3/8-16 Nylon Insert Lock Nut
(8) 3/8 Flat Washer
TOOLS NEEDED
• Primer, paint, cleaners (if painting)
• 9/16” end wrench, socket and ratchet
• 3/4” end wrench or socket and ratchet
(optional)
BEFORE YOU BEGIN
If your RockBrawler Hi-Lift Jack Mount came
as unpainted, bare steel, you will want to either
powder coat or paint the it prior to install. If
painting yourself, careful preparation will make a
big difference in the quality and longevity of your
paint job, even using “rattle can” aerosol paints.
Begin by thoroughly cleaning the bumper with
solvent or de-greaser, then make sure all residue
is removed. Even if you use cheap paint, try to
use a good quality primer. “Etching” primers are
best to use on bare, unpainted metal. Allow it to
properly dry before painting, and between paint
coats.
Note that you must already have both a
RockBrawler Rear Bumper with Tire Carrier and
a Hi-Lift jack. The Jack must have the lifting
mechanism at the bottom of its travel, with the
handle locked into place. The handle must
be secured by some mechanism such as the
urethane jack handle isolators that are available
at most 4X4 shops.
INSTALLATION PROCEDURE
1. Park the Jeep on a flat, level surface and
set the parking brake.
2. Remove the spare tire from the RockBrawler
Bumper Tire Carrier, if present.
3. Use the 3/8-16 Hex Head Cap Screws, Flat
Washers and Nylon Insert Lock Nuts to attach