Poison Spyder JK BRAWLER MID FRONT BUMPER - Manual

INSTALLATION INSTRUC
TIO
NS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
The Poison Spyder Customs Brawler MID
Front Bumper is easy to install with the right
tools and good mechanical abilities. If you are
not confident in your mechanical skills, please
seek the help of a professional to perform the
installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything listed is included,
and to check for damage during shipping. The
locknuts and washers are shipped attached to the
mounting studs inside the bumper. If anything is
missing or damaged, call Poison Spyder at (951)
849-5911 as soon as possible.
(1) JK Brawler MID Front Bumper
(8) 1/2-13 nylon insert lock nut
(8) 1/2 flat washer
TOOLS NEEDED
• Ratchet with 6” socket extension, 19mm
deep socket and 3/4” deep socket
• Torque wrench (ft./lbs.)
• 7/32” hex key
• Dead blow hammer or rubber mallet
• Phillips & flat head screwdrivers
• Removal tool for push-in retainer clips or
small pry bar
BEFORE YOU BEGIN
The JK Brawler MID Front Bumper and
associated components are shipped un-painted.
Before you paint or powder coat, perform the
entire installation of the product to ensure that
it fits without risking damage to your paint or
powder coat finish. Poison Spyder Customs is
not responsible for paint or powder coat costs
in the event you damage the finish during
installation, or that the parts are incorrect or
defective.
You will want to paint or powder-coat these
components prior to FINAL installation. If
painting them yourself, we recommend starting
with a quality etching primer and allowing
sufficient cure/dry time between coats and
before you apply color. Quality spray-can paints
are fine, however be sure to thoroughly paint all
of the inside corners and hard-to-reach areas
of the bumper. A little extra time and attention
to detail on your preparation and paint process
will pay off in longer-lasting good looks and rust
prevention.
INSTALLATION PROCEDURE
1. Park vehicle on a level surface and set the
emergency brake. You will want to wear eye
protection beyond this point.
2. Remove the plastic lower air dam. Use a
push-in retainer removal tool to pop out the
plastic push-in retainers along the front edge
and also underneath/behind the air dam
where it attaches to the crash bar. If you do
not have a push-in retainer tool, a flat-edge
screwdriver or small pry-bar may be used.
FIGURE 2
JK BRAWLER MID FRONT BUMPER
INSTALLATION