Poison Spyder LJ TRAIL CAGE KIT - Manual

©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUC
TIO
NS
TJ-LJ TRAIL CAGE KIT INSTALL
11
10
9
4
7
Thank you for purchasing a Poison Spyder Full
Cage Kit for your Jeep TJ. Poison Spyder’s
innovative Lazer-Fit technology provides for the
easiest, fastest installation of any aftermarket full
cage kit on the market. Installation does require
specialized skills and tools, such as welding. If
you are not confident in your mechanical skills,
please seek the help of a professional to perform
the installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything listed is included,
and to check for damage during shipping. If
anything is missing or damaged, call Poison
Spyder at (951) 849-5911 as soon as possible.
(2) Lower A-Pillar L&R 4
(2) Upper A-Pillar Tube L&R 7
(1) Dash Bar 9
(1) A-Crossbar 10
(2) Forward Stringer L&R 11
(2) 1/2-13 X 2-1/2 Gr8 Hex Head Cap Screw
(2) Washer Plate
(2) 1/2-13 Grade ‘C’ All-Metal Lock Nut
TOOLS NEEDED
• Mechanic’s tool set including Torx bits
• Welder and proper welding equipment
• Protective welding blankets
• Square and measuring tape
INSTALLATION NOTES
Installation of the Trail Cage Kit can take up to 4
hours. This kit requires welding, which should
be done by a certified welder. You will need a
friend or two to assist with the installation.
IMPORTANT: It is imperative that the top, doors,
seats, plus any other components that are going
to be reinstalled after the cage install be test-
fitted BEFORE final welding of the cage! Poison
Spyder Customs is not liable for fitment issues
due to negligent install.
INSTALL PROCEDURE
NOTE: Throughout these procedures, refer to
the assembled trail cage diagram in Figure 1 for
reference identification and in proper general
orientation of cage components. In most cases,
the laser-cut notches and laser-etched assembly
marks will eliminate all guesswork. Regardless,
carefully inspect each part and its placement