Poison Spyder JK 07-10 BOLT-TOGETHER TRAIL CAGE - Manual (Page 3)

INSTALLATION INSTRUC
TIO
NS
©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs • JK BOLT-TOGETHER TRAIL CAGE KIT Page 3
FIGURE 2
FIGURE 3
7. On the forward sheetmetal piece of the
factory header bar, locate the two screw clips
where the sun visor had attached. Remove
each one by pinching the metal clip from the
back side and pushing it out.
FIGURE 4
8. Look along the underside of the top of the
windshield frame, at each end, and locate the
rectangular hole with two smaller rectangular
holes (and a round hole) in the panel behind.
Insert the screw clips removed from the factory
header bar into the two small rectangular
holes, as shown in the photo below. You may
need to file a small amount of material off the
end of each clip for a proper fit. Push them in
until they are fully seated.
FIGURE 5
9. Remove the windshield wipers. Pry up the
plastic cover at the pivot point of the wiper
to expose the nut. Use a 13mm wrench to
remove the nut, then slide the wiper arm off
of the shaft.
FIGURE 6
10. Use a Torx T40 driver bit to remove the
windshield brackets from the lower corner
of each end of the windshield, then tilt the
windshield forward into the rubber bumpers
on the Jeep’s hood.
FIGURE 7