Poison Spyder LED TAILLIGHTS & FLASHERS - Manual

INSTALLATION INSTRUC
TIO
NS
©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
LED TAILLIGHTS & FLASHERS INSTALLATION
LED TAIL LIGHT INSTALLATION
Poison Spyder Customs 4” LED taillights
are designed to work with Poison Spyder
Crusher Corners that were specifically made
for aftermarket LED taillights. They also work
with other manufacturer’s corner protectors, or
on Jeeps without any corner protectors. In all
cases, a 4-1/2” round hole must be cut into corner
protector or sheet metal to install the LED (plus
screw holes for the flange-mount style LED).
These instructions do not cover the procedure
for creating this mounting hole, it is assumed that
it is already present or you purchased Poison
Spyder Crusher Corners already made for LED
taillights.
1. Pull the factory wiring harness taillight plug
through the 4” LED hole to have room to
work.
2. Cut the factory taillight plug from the stock
taillight pigtail (between the plug and the
taillight). You will re-use the taillight side of
this plug. Leave as much wire as possible.
3. Use the information in Table 1 to make
the correct connections between the cut
wires from the factory taillight plug, and the
black and red wires in the supplied LED
pigtail harness. Whether you solder or
crimp-connect, we recommend using heat-
shrink tubing on all connections. Once the
necessary electrical connections have been
made, plug the OEM pigtail plug (now with
the LED pigtail attached) back into plug in
the Jeep’s chassis harness. Do not plug the
opposite end of the pigtail into the LED lamp
fixture at this time.
4. Tape-off unused wires in the stock harness.
These will be the violet/black wire on both
sides (unless you are wiring your own,
separate back-up lights) and the green/red
wire on the passenger side, which is unused.
Stow these wires inside the wire loom or zip-
tie them securely to the harness.
5. Properly ground the white wire in the LED
pigtail harness to your Jeep’s body. The
push-in style LED’s come with a ring terminal
already connected to the white wire. With
the flange-mount style LED, you will need to
add a ring terminal to the white ground wire.
Use a sheet metal screw or self-tapping
(“tek”) screw to secure the ground. Be sure
41-04-050
4” Red 24-LED Push-In
41-04-026
4-Pin LED Flasher 97-2000 TJ
41-04-051
4” Clear 24-LED Push-In
41-04-106
5-Pin LED Flasher 01-06 TJ/LJ
41-04-010
4” Red 6-LED Flange Mount
41-04-262
2-Pin LED Flasher 76-95 CJ/YJ