Poison Spyder TRAMP STAMP - Manual

©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUC
TIO
NS
Thank you for purchasing a Poison Spyder Tramp
Stamp for your Jeep YJ, TJ or LJ. The Tramp
Stamp installs over the body sheet metal below
the tailgate, finishing off your Poison Spyder
body armor in style. Installation is fairly simple
with the right tools and good mechanical abilities.
If you are not confident in your mechanical skills,
please seek the help of a professional to perform
the installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything listed is included,
and to check for damage during shipping. If
anything is missing or damaged, call Poison
Spyder at (951) 849-5911 as soon as possible.
(1) Tramp Stamp
(8) 3/16” Truss head pop rivet, black
TOOLS NEEDED
• 3/16” transfer punch or fine-tip marker
• 13/64” drill bit and drill motor
• Pop rivet install tool
• Touch-up paint or clear coat
INSTALLATION PROCEDURE
1. Park vehicle on a level surface and set the
emergency brake. Remove any stickers,
brackets, license plate holder or any other
obstruction from the area below the tailgate
where the Tramp Stamp will be installed.
Clean the area, straighten any bends or
creases in the sheet metal, and sand/
primer/paint any bare metal to prevent rust
underneath the Tramp Stamp.
2. Prep the Tramp Stamp for installation by
painting, powder coating, polishing it or
leaving it bare. The Tramp Stamp is made
of aluminum plate, so it won’t rust but it
will oxidize slightly over time if left bare or
polished. If you paint it, thoroughly clean and
lightly scuff with a sander prior to applying an
initial coat of primer, followed by your paint
color of choice.
3. Hold the Tramp Stamp in place over the
rectangular sheet metal section below the
tailgate. There is some room for adjustment,
so make sure the gaps at either side and
along the top are all even while holding the
Tramp Stamp in place.
4. Use the transfer punch or fine-tip marker
to mark the 8 hole locations using the Tramp
Stamp itself as the template, then set the
Tramp Stamp aside.
5. Drill each of the marked hole locations
with a 13/64” bit. Be careful not to let the
bit “catch” and deform the sheet metal as it
breaks through.
6. Clear any burrs from the holes, then use
some touch-up paint or clear coat to protect
the bare metal around the edges of the holes
from future rust.
7. Place the Tramp Stamp back into position
and use your pop rivet tool to install the
supplied rivets through the 8 holes. Make
sure the Tramp Stamp is level and centered,
and begin by installing rivets on two opposite
corners to securely hold the Tramp Stamp
while you install the remaining rivets.
Congratulations, you have completed the
installation of your Poison Spyder Tramp Stamp!
TRAMP STAMP INSTALL INSTRUCTIONS