Poison Spyder CRUSHER CORNERS - Manual

INSTALLATION INSTRUC
TIO
NS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
CRUSHER CORNERS INSTALL PROCEDURE
Thank you for purchasing Poison Spyder
Crusher Cornersr™ for your Jeep. Installation is
fairly simple however care and patience must be
used to ensure the best installation. If you are
not confident in your mechanical skills please
seek the help of a professional to perform the
installation. Please read through these entire
instructions before proceeding with installation.
Note: Install Instructions apply for models with
and without DeFender™ Flares.
IMPORTANT: Completely install and remove the
Crusher Corners™ prior to painting or powder
coating it. This will allow you to check for fitment
or do any clearancing or fitting ahead of time, to
reduce the chance of damage to the finish during
final installation. Poison Spyder Customs Inc. is
not responsible for costs for or damage to paint
or powder coat finish under any circumstances,
including paint or powder coat of incorrectly
shipped or defective parts.
IMPORTANT: Please check your packages
immediately upon arrival to ensure that
everything listed below is included, and to check
for damage during shipping. If anything is
missing or damaged, call Poison Spyder at (951)
849-5911 as soon as possible.
PARTS LIST
(1) Driver Side Crusher Corner
(1) Passenger Side Crusher Corner
(x) 3/8-16 SS Flat Head Cap Screw*
(x) 3/8-16 Nylon Insert Lock Nut*
(x) 3/8 Flat Washer*
*Quanitiy “x” varies by Jeep model:
(22) CJ7
(18) CJ7 Comp Cut
(22) TJ
(20) TJ Comp Cut
(24) YJ
(20) YJ Comp Cut
(30) LJ
(26) LJ Comp Cut
(y) 3/8-16 Nut-sert**
**Quanitiy “y” varies by Jeep model:
(2) CJ7
(0) CJ7 Comp Cut
(4) TJ
(2) TJ Comp Cut
(2) YJ
(0) YJ Comp Cut
(4) LJ
(2) LJ Comp Cut
TOOLS NEEDED
• Primer & paint (unless Corners have
already been painted or powder-coated)
• Fine tip felt marker (Sharpie ® or similar)
• 7/32 hex key (Allen wrench) or hex socket
• 9/16 combination open end/box end
wrench and/or socket with ratchet
• Drill motor with 3/8” & 17/32” (optional) drill
bits
• 1” hole saw (optional) & 4-1/2” hole saw
(optional if installing LED taillights)
• Auto-punch or center punch with hammer
• C-Clamps, welding clamps or similar, and/
or a helper
• Pneumatic body saw, nibbler, electric jig-
saw with bi-metal blade, or die grinder with
cut-off wheel (optional if installing Comp