Poison Spyder CJ LOWER A-PILLAR LIGHT MOUNTS - Manual

©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUC
TIO
NS
Thank you for purchasing Poison Spyder
products for your Jeep. Installation is fairly simple
with the right tools and good mechanical abilities.
If you are not confident in your mechanical skills,
please seek the help of a professional to perform
the installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything listed is included,
and to check for damage during shipping. If
anything is missing or damaged, call Poison
Spyder at (951) 849-5911 as soon as possible.
(1) Driver Side Lower A-Pillar Light Mount
(1) Passenger Side Lower A-Pillar Light
Mount
(1) Driver Side Lower A-Pillar Rubber Liner
(1) Passenger Side Lower A-Pillar Rubber
Liner
(4) 5/16-18 X 1 SS Button Head Cap Screw
(4) 5/16-18 Nylon Insert Lock Nut
(8) 5/16 SS Flat Washer
INSTALLATION NOTES
•
This product is designed primarily for
mounting the Rigid Industries Dually or
Dually D2 LED lights. No guarantee is made
regarding fitment of other brands of off-road or
auxiliary lights, however it will likely work with
most lights that are in a compact housing. The
light mounting hole is 7/16”.
• Remove the two Torx bolts (T40 driver bit)
on the front-ward side of the lower half of the
windshield hinge. There are hex nuts (1/2”
wrench) on the opposite ends of these Torx
bolts, behind the dash. Its tricky to get to them
without un-bolting the dash, but enlisting the
help of a friend or child with small hands may
do the trick.
• Place the rubber liners between the mount
and the lower A-pillar, to protect the Jeep’s
paint.
• Use the provided stainless steel button
head cap screws (3/16” hex key), flat washers
and lock-nuts (1/2” wrench) to secure the light
mount to the lower windshield hinge.
FIGURE 1
YJ-CJ LOWER A-PILLAR LIGHT MOUNTS