Poison Spyder JK LED LICENSE PLATE & 3RD BRAKE LIGHT - Manual (Page 5)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • JK LED License Plate & 3rd Brake Light Install Page 5
©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 17
18. Reinstall the white plastic pin lock into the
open end of the taillight connector. Use a
pick or screwdriver to push it in until it locks
into place.
FIGURE 18
19. Plug the Poison Spyder LED Taillight
Harness into the OE taillight connector.
FIGURE 19
20. Route the long gray license plate light
lead to wherever you are going to mount the
license plate light, typically at the center of
the spare tire on the spare tire carrier. To
route the wire to the exterior of the Jeep,
reach inside the Jeep’s corner cavity, down
to the “floor” inside. There is a hole in this
floor under a thick piece of foam insulation.
This hole can be used to route the wiring to
the exterior of the Jeep.
21. Use hardware of your own choosing to
mount the License Plate & 3rd Brake Light
along with the license plate in the location
you have chosen. Use zip-ties to secure
the wiring lead along its path. Make sure it
has enough slack at the tire carrier hinge to
provide for full movement of the tire carrier.
22. Continue with the remaining steps of the
JK LED Taillight Harness installation from the
instructions included with that product.
Congratulations, you have completed the
installation of your Poison Spyder JK LED
Taillight Harness!