Defi ADVANCE Control Unit (DF07703 Manufactured in and before January, 2012) - Manual (Page 5)

Warning
Carefully consider the installation location and driver's operation of the
product before installation. Do not install the product where it interrupts
driving and the safety deices of vehicle such as air bags. Be sure not to
install the unit where it could fall. Improper installation or operation could
cause the product to fall and damage the vehicle or cause serious danger
by impeding driving.
Do not disassemble or modify this product. Such actions can
not only damage or destroy the product but also will void the
warranty.
Do not perform installation of this product immediately after the engine has
been switched off. The engine and exhaust system are extremely hot at this
time and can cause burns if touched.
Ensure that the wiring of this product does not have an adverse impact on
the other wiring of the vehicle. Before tapping speed or engine rev signal
from the ECU, please make sure that you have connected power cables
inside power supply wire properly. Then confirm that the DC Source LED
is lighted with ignition on. If it is functioning normally, remove negative
terminal connector from battery and go ahead with wiring procedure.
Incorrect wiring may destroy your ECU, ignition system and other engine
management devices.
Please keep children and infants away from the installation area. Children
may swallow small parts or be injured in other ways.
Do not install this product in the area where safety equipment such as air
bags are mounted. This may cause more injuries in the event of accident.
Caution
This product is designed for use on 12V vehicles. Do not install
this product on vehicles with 24V systems.
Insulate any unused wires. If any wires or connectors loosen during installa-
tion, please make sure they are correctly reattached.
Do not drop any of the components of this product. It may result in dam-
age to the product.
Disassemble/
Modify
24V
43