Defi Link Meter - Manual (Page 30)

83
OIL TEMP.
Use a commercial sensor attachment
●Be sure the sensor wire is not twisted when installing the sensor. The sensor wire will be cut.
●The thread size of the temperature sensor is 1/8PT. If the thread size of the sensor
attachment for the temperature sensor is 1/8NPT, you will need the 1/8NPT
temperature sensor (optional part).
●Tighten the sensor into the sensor attachment and then connect it to the sensor wire.
CONFIRMATION
WARNING
●To avoid oil leaks during installation of the sensors, use Teflon tape. Before driving,
inspect tubing and oil blocks for leaks. Leaks could cause a fire or damage the engine.
●Oil spills by the installation work. Please replenish the engine with oil. The engine
might overheat when oil is too little.
●To avoid the damage of sensor wire, please fix the waterproof connector on the vehicle body.
Engine
Detach the original
element
Engine
Sensor attachment
(commercially available)
O ring
→ To sensor wire
Sensor
Wind Teflon tape.
Thread size 1/8PT
Be sure not to
twist.