PureFlow AirDog DF-200 - Dodge Cummins 2005-2013 - Manual (Page 20)

20
PureFlow AirDog
AirDog
®
II DF-200 Dodge 2005 - 2011
Section 6 Electrical Harness
Securing the Relay and Fuse Holder to the Vehicle
6-1. Secure the relay and fuse holder to the vehicle.
Figure 42 Figure 43
Connecting the AirDog
®
Power Lead Jumpers
6-2. Remove the factory wire harness connection from the top of the fuel module as seen
in (Figure 45)
Figure 44
6-3.
Plug the AirDog female power lead jumper into the top of the fuel module.
6-4 After a “click” is heard, slide the red locking clip over to lock the connection in place.
6-5. Plug the factory wire harness connector into the AirDog male power lead jumper.
Again, listen for the “click”.
NOTE: The power supply leads can be connected to the battery or the alternator. Connecting
the power supply leads to the alternator instead of the battery will create a corrosion free
connection.
Black (-) Red (+)
6-6. Route the Red & Black power supply
leads to the alternator. Connect the
Black (-) lead to the alternator
Chassis Ground connection. Connect
the Red (+) lead to the alternator Hot
Lead going to the battery.
Figure 45