PureFlow AirDog RP-150 - Dodge Cummins 2005-2013 - Manual (Page 9)

9
Raptor™ 100 & 150
2005 – Present Dodge Cummins
Section 4 Raptor™ Fuel Pump & Mounting Brackets
Section 4: Mounting the Raptor™ to the Truck’s Frame.
The Raptor™ Fuel Pump is best mounted with the electric motor up, as shown.
4-1. Install 1/2” O-ring Boss X 3/4” male fitting (08J2044-3/4UNF) into the Raptor™ port
marked “IN”.
FUEL “IN” PORT FUEL “OUT” PORT
Figure 2
4-2. Install 1/2” O-ring Boss X 3/4” male fitting (08J2044-3/4UNF) into the port marked
“OUT”. Properly torque the fitting.
NOTE: The kitting provided is intended for inside frame rail mounting. Mounting inside the
frame (Fig. 4) will give more protection from road debris.
Figure 3 Figure 4
4-3.
Assemble the Raptor™ to the mounting bracket as shown in Fig. 3. Hold the assembly
next to the selected location on the frame to check for clearance (Fig. 4). Adjust the
Raptor™ up or down on the mounting bracket to clear fuel lines or wiring on the frame.
Use the spacer block to clear lines and wiring harnesses on the frame.
4-4. Loose assemble the mounting bracket and pump assembly to the frame with the backing
plate using the 4 ½” x 3/8” bolts, lock washers, and nuts. After satisfactorily positioning
the bracket and pump assembly, properly torque the fasteners.
Figure 5
Figure 6
NOTE: Some pickup model frame rails have a bracket that is used to support the frame during
the manufacturing process. If this bracket is on your frame rail and obstructs the proper
positioning of the Raptor™ mounting bracket, you may remove it! Be very careful not to damage
the frame.