PureFlow AirDog FRRP-100 - Dodge Cummins 1998.5-2002 - Manual (Page 7)

7
INSTALLING THE FRRP-100
1. Replace the 2 original sealing washers on the stock banjo fitting with the 2 new ones
provided (part# 1P-5-DS).
2. Firmly tighten the factory fuel supply line in the inlet port of the FRRP using the factory
banjo fitting. The factory support bracket is no longer used.
3. Install the Boss O-ring fitting (part# 4A-1-02-08-08-S) into the outlet port of the FRRP
and tighten firmly.
4. Firmly tighten the FRRP to the stock bracket using the hardware supplied. See Fig 2
Fig 2
5. Install the 12mm X ½” Male SAE J2044 Quick Connect Fitting (part# WAP102) with
seal washer supplied into the inlet port on the fuel filter canister. Do not over tighten.
The fitting could crack or break! See Figures 3 & 4.
1998.5 - 1999 2000 - 2002
Figure 3 Figure 4
Note: Figures 3 & 4 depict a push lock style connection. This kit is supplied with connects as
shown in the parts list.
6. Connect the quick connect end of the “Output Hose Assembly” (part# WAP122-8-90)
(See Figure 5) to the inlet fitting installed in step 5. It will “click” when properly
connected.
Figure 5