PureFlow AirDog RP-150 - GM 1992-2000 - Manual (Page 9)

9
Raptor™ 100 & 150 1992 – 2000 Chevy Diesel
Section 4 Pump & Mounting Bracket
Mounting the Raptor™ to the Truck’s Frame.
The Raptor™ Fuel Pump is best mounted with the electric motor up, as shown!
4-1. Install 1/2” O-ring Boss X 3/4” male fitting (08J2044-3/4UNF) into the Raptor™ port
marked “IN”.
FUEL “IN” PORT FUEL “OUT” PORT
Figure 2
4-2. Install 1/2” O-ring Boss X 3/4” male fitting (08J2044-3/4UNF) into the port marked
“OUT”. Properly torque the fitting.
NOTE: Mounting the Raptor™ inside the frame gives protection from road debris.
Figure 3 Figure 4 Figure 5
4-3.
Assemble the Raptor™ to the mounting bracket as shown in Fig. 3. Hold the assembly
next to the selected location on the frame to check for clearance (Fig. 4). Use the spacer
block to clear fuel lines or wiring on the frame, adjust the Raptor™ up or down on the
mounting bracket as necessary.
4-4.
Loose assemble the mounting bracket and pump assembly to the frame with the backing
plate using the 4” x 3/8” bolts, lock washers, and nuts. After positioning the bracket
and pump assembly at the selected location, properly torque the fasteners.