CARR 102564 Hoop II Multi-Mount Step User Manual
CARR For the car
Materials Needed:
Phillips screwdriver, pencil, center punch, drill motor, sharp 1/8" drill bit, sharp 5/16" drill bit,
10mm socket and socket wrench, 2 ½" open or box end wrenches, rags.
Materials Furnished:
Two Hoop II Steps, Four Mount Feet, Four Steel Brackets, Two Hardware Packs, Instruction.
HOOP II MULTI-MOUNT STEP INSTALLATION INSTRUCTIONS
Part No.’s: 102561, 102562 & 102564
WARNING: Do not over tighten nuts and bolts, or damage to the casting and or stripping of the threads could result.
WARNING: FOR SAFE AND PROPER USAGE OF THIS PRODUCT, THE MOUNTING INSTRUCTIONS MUST BE FOLLOWED CAREFULLY AND COMPLETELY.
IMPORTANT:The manufacturer and distributor of this product are in no way responsible for the consumer's failure to adhere to the warnings and directions of these instructions,
in the event of damage to the consumer's vehicle, other properties and or personal injury.
WAX YOUR STEP
WAX YOUR STEP
WAX YOUR STEP
WAX YOUR STEP
ON A REGULAR
ON A REGULAR
ON A REGULAR
ON A REGULAR
BASIS TO
BASIS TO
BASIS TO
BASIS TO
MAINTAIN ITS
MAINTAIN ITS
MAINTAIN ITS
MAINTAIN ITS
LUSTER!
LUSTER!
LUSTER!
LUSTER!
STEEL BRACKETS
BODY METAL
ITS PAINTABLE
All of the bright finished products can be painted to whatever color you like. Simply sand your bright finished step lightly
all over, prime it with “Synthetic Zinc Chromate Primer”, let dry, and it’s ready to paint.
STANDARD VERTICAL MOUNT
CHEVY / GMC
‘92-‘99 SUBURBAN / ’92-‘99 YUKON/TAHOE
DRIVER’S SIDE SHOWN
MOUNTING FEET