CARR 210221 Jeep XRS Rota Light Bar User Manual
Xrs rota jeep mounting instructions, Detail a
Quality and Style that Endures
Follow the diagram and the written
directions carefully for a proper,
safe installation.
Should you encounter an unusual,
unforeseen problem, contact our
Technical Help Line
7:00 AM – 3:00 PM Pacific Time
(951) 719-1068
Visit our web-site at
www.CARR.com
Carr Pattern Co., Inc.
MATERIALS NEEDED: Wrench for 8mm Torx Bolts or an 3/16” Allen wrench,
Loctite
MATERIALS FURNISHED: Two Mounting End Brackets (3), two Rota Square
Castings (2), two Rota Hood Castings (1), one Cross Bar, and one Hardware Pack.
XRS ROTA JEEP MOUNTING INSTRUCTIONS
Part No. 210221
THIS LIGHT BAR FITS THE FOLLOWING VEHICLES:
JEEP
’07 – ’14 X/Sahara/Rubicon Wrangler
Rubber Gasket
Existing 8mm Torx
Bolts and Washers
Rubber Grommet
Welded Nut
Cross Bar
5/16” Bolt
3/8” Bolt
1/4” Socket Bolts &
Nylon Black Washers
Rota Hood Casting (1)
Rota Square Casting (2)
Mounting End
Bracket (3)
Detail A
Feed the wires from your
lights through these three
loops on back of the
Mounting End Brackets.