CARR 210444 Light Bar - Manual

Quality and Style that Endures
Follow the diagram and the written
directions carefully for a proper,
safe installation.
Should you encounter an unusual,
unforeseen problem, contact our
Technical Help Line
7:00 AM – 3:00 PM Pacific Time
(951) 719-1068
Visit our web-site at
www.CARR.com
Carr Pattern Co., Inc.
WARNING!
THIS CARR LIGHT BAR IS DESIGNED TO HANDLE A TOTAL
WEIGHT OF FOUR (4) LBS. ANY ADDITIONAL WEIGHT
BEYOND THIS CAPACITY, MAY RESULT IN SERIOUS
DAMAGE TO YOUR VEHICLE AND/OR ANOTHER VEHICLE.
MATERIALS NEEDED: Drill motor, 5/16” drill bit, hammer, center punch, ½”
drill bit, hacksaw.
MATERIALS FURNISHED: One hardware pack, two end castings, cross bar,
instruction page.
LIGHT BAR MOUNTING INSTRUCTIONS
Part No’s: 210441, 210442 & 210444
THIS LIGHT BAR FITS THE FOLLOWING VEHICLES:
JEEP
‘76 – ‘95 Jeep CJ/YJ Wrangler
Mounting End Castings
Cross Bar
5/16" Bolt
1/4" Bolt
Split Lock Washer
Windshield
Bend Rubber Gasket
This is the open end of the Mounting
End Casting. Measure from this point
on each Mounting End Casting.
(See step 11 on the Light Bar Mounting
Instruction)
Tinnerman Nut