Hornady 366 AP Loader - Manual (Page 13)

13
Step 8: STATION SEVEN (Crimp)
Fig. 9: Crimp
As you pull the handle (#37), the shell in Station Seven will enter the crimp die (#59). The
shell will contact the inside of the die and raise the die body (#59) as it goes up. It will then
contact the crimp plunger (#58) and the crimp will be closed. On the return stroke, the shell
will be pulled from the crimp plunger (#58) but the crimp die (#59) will keep pressure on the
case to retain the proper shape. Since different manufactures’ cases have varying types of
construction, different settings are required for best results. The two-stage die enables the user
to create a reloaded round that has approximately the same tapered mouth as a factory shell.
There are two adjustments to the crimp die assembly (#57, #58, and #59); the larger outer
position adjusts the die body (#59), the threaded bolt through the center of the die adjusts the
crimp plunger (#58). To adjust the die, refer to the number of threads exposed above the large
die body locking nut (#15) as reference points for each brand of case. For Winchester AA type
shells, ten to ten and one half threads should remain above the locking ring (#15); for
Remington Blue Magic and Federal Gold Metal Cases, eleven to thirteen threads should be
exposed. These measurements are approximate and may need adjustment up or down,
depending on the plastic and components, but should be correct in most situations. Before
adjusting the crimp the crimp die (#59), the crimp plunger (#58) should be raised a few turns
by loosening lock nut (#15) and turning the crimp die bushing (#57) clock wise. Then, make
the necessary die body (#59) adjustments, and follow by crimping the case. At this point, the
case mouth will not be closed. Lower the crimp plunger (#58) in small increments, each time
recrimping the shell until the final desired crimp depth is obtained. The crimp depth is up to
you, but excessive depth shortens case life, while a crimp that is too shallow will not yield
uniform velocity or good patterns. A good practice is to keep a factory round on hand for
reference