PowerBridge TWO-CK - Manual (Page 2)

Step 2
Wall Installation
A) Begin at the upper PowerOUT location.
Drop or wall-fish audio video cables FIRST, to the PowerIN
location below.
REPEAT for PowerConnect cable with connector.
Pull all cables out lower cutout.
Step 3
Plug it in
Plug TV power supply cord in to PowerOUT and connect AV cables to TV.
Follow wall mount manufacture instructions, install TV on wall bracket.
Plug supplied 6’ PowerConnect cord into PowerIN.
Plug other end into existing grounded outlet or surge protector.
CAUTION-Risk of Fire-Only Use Cord Set Provided With This Kit
or equivalent.
To disconnect PowerConnectors, push-in end of Locking Latch on the TOP side of both connectors.
Press with finger tips at the same time pulling apart connectors to disconnect from Locking Tabs.
!
Locking Tab
Locking Latch
!
B) Slide audio video cables through backside of CableBrush.
Allow for enough cable length out to connect to TV.
C) Slide PowerOUT into wall opening.
Use Flat-Blade screw driver to secure panel to wall.
Careful to not over-tighten.
D) At PowerIN location, connect both PowerConnect Cable
connectors together. These are tight by design and require some
pressure and wiggling to secure.
You should hear a click sound locking both connectors together.
F) Slide PowerIN panel into wall opening.
Use Flat-Blade screw driver to secure panel to wall.
Careful to not over-tighten.
The PowerBridge In-Wall Extension is now energized.
Drop or wall-fish audio/video cables within wall
BEFORE PowerConnect cable
E) Slide audio video cables through backside of CableBrush.
Allow for enough cable length out to connect to AV equipment.
Existing
Outlet
Surge Protector
Listen
for the
Click
Plug in TV Plug in Flat Angle Plug