PowerBridge SBCK - Manual (Page 2)

Step 2
Wall Installation
A) Begin at the upper TV PowerOUT location.
1) Drop / wall-fish audio cables to the SoundBar
2) REPEAT for PowerConnect cable with connector.
3) Pull PowerConnect cable and audio cable through SoundBar cutout.
Step 3 Plug in SoundBar power cord. Wind cord in cavity.
Install SoundBar per manufactures directions.
To disconnect PowerConnectors, push-in end of Locking Latch on the top side of both connectors.
Press with finger tips at the same time pulling apart connectors to disconnect from Locking Tabs.
!
Locking Tab
Locking Latch
B)
together to the short 1’ top PowerConnect Cable of the SoundBar.
You should hear a click sound locking both together.
C) Drop / wall-fish 6’ PowerConnect cable down
to the PowerBridge PowerIN location.
D) Slide any audio cables from the TV through cable opening.
Connect the upper PowerOUT PowerConnect Cable connectors
E) Slide SoundBar power panel into wall opening.
Use Flat-Blade screw driver to secure panel to wall.
Careful to not over-tighten
F) At PowerIN location, connect both PowerConnect Cable connectors together.
You should hear a click sound locking both connectors together.
Complete installation of PowerBridge Power Kit .
A1) Audio Cables from TV
A2) PowerConnect (TV)
A3) SoundBar opening