PowerBridge LP2D - Manual (Page 2)

Step 2
PowerOUT Installation (Upper Panel)
A) Begin at the upper PowerOUT location where TV will be mounted.
Drop or wall-fish audio video cables and in-wall PowerWire
extension to the PowerIN cutout location.
Step 4
Power UP
Plug TV power supply cord in to PowerOUT and connect AV cables to TV.
Follow wall mount manufacture instructions, install TV on wall bracket.
Surge Protector
Plug supplied 6’ PowerConnect cord into PowerIN.
Plug other end into existing grounded outlet or surge protector.
Do not use another extension cord to extend the supplied cord.
!
Plug in TV Plug in Flat Angle Plug in the far right receptacle
if using the left for another device. (Sound-Bar)
B) Push in-wall PowerWire extension through the slot closest to the
middle of the attached wiring box.
Push through approximately 6”
D) Slide PowerOUT panel into wall opening. Use Flat-Blade screw driver to secure panel to wall.
Careful do not over-tighten.
Your PowerBridge In-Wall Extension is now energized.
Existing
Outlet
C) Slide audio video cables through backside of CableGate.
Optional: Cable zip-tie straps can be used to secure cables through CableHoops.
Use needle nose pliers
to bend the end of the
BARE Ground wire in to
a “J” hook shape as shown
Hook the BARE GROUND
wire around the GREEN
screw, clockwise, as shown.
This is only for the BARE wire .
Use Philips Screw driver,
tighten the GREEN screw
E) Dual Outlet Wire Connection
Insert BLACK wire
in the small hole
next to the GOLD
screw.
Insert the wires
completely in,
to lock securely.
Insert WHITE wire in the small hole
next to the SILVER screw.
Secure Outlet Cover Plate
Careful do not over-tighten
Secure the Dual Outlet
to PowerPanel
Step 3
PowerIN Installation (Lower Panel)
!
Wire Connection
E) Secure the PowerINLET
to PowerPanels with
supplied slotted screws.
Insert BARE wire into the yellow wire
port with GREEN wire.
Insert WHITE wire into the yellow wire
port with WHITE wire.
Insert BLACK wire into the yellow wire
port with BLACK wire.
Insert wires
completely into
the wire-ports to
lock wires securely.
!
A) Push in-wall PowerWire extension through the slot closest to the
middle of the attached wiring box.
Push through approximately 6”
B) Slide audio video cables through backside of CableGate.
Optional: Cable zip-tie straps can be used to secure cables through CableHoops.
!
C) Slide PowerIN panel into wall opening. Use Flat-Blade screw driver to secure panel to wall.
Careful do not over-tighten.
LP2D v1.413
D) Inlet