PowerBridge TSPBIW (All TS Series) - Manual

~ TOOLS REQUIRED ~
* IMPORTANT PRODUCT INFORMATION *
*BEFORE YOU START: Check with your local building jurisdiction as to permit, license or code requirements for installing wire or outlets
within a wall . Some municipalities require an electrical inspection for any modification of electrical work. HD-Products, recommends all
modifications or alterations of existing or new electrical work to be inspected by a licensed electrical inspector.
 THIS PRODUCT IS NOT TO BE INSTALLED, DIRECT WIRED, CONNECTED OR BRANCHED TO THE BUILDING ELECTRICAL
CIRCUIT/WIRING SYSTEM !
INSTALL THIS PRODUCT ONLY AS AN ELECTRICAL EXTENSION PLUG-IN DEVICE TO AN EXISTING, A/C GROUNDED OUTLET TO
ENERGIZE A/C POWER USING A UL LISTED PLUG-IN CORD SET WHEN INSTALLED WITH SPECIFIED CODE COMPLIANT BUILDING
ELECTRICAL WIRE. > Install this product to meet National Electrical Code and or State/Local Building Code as to requirements for installing
electrical building wire and outlets as a single EXTENSION CIRCUIT, without modification or alteration to the building electrical circuit/wiring
system.
THIS PRODUCT MUST BE INSTALLED TO A UL CLASSIFIED SINGLE GANG ELECTRICAL JUNCTION BOX TO MEET CODE COMPLIANCY
AND TO ASSURE SAFETY. > The supplied non-metallic junction boxes may not meet some local code requirements, as metal junction boxes
may be required for certain installations where it may require Metal-Clad or Armored-Clad building wire.
Please read and understand all instructions. Follow WARNING and CAUTION labels on the product. Use 12-2 or 14-2 Copper Utility [CU] wire
only with this product. This product is rated to use with an existing A/C outlet 125v grounded circuit only. For shock protection, do not install
this product to a non-grounded outlet/system.
Do not install this product near water, example, near a sink, tub, shower, swimming pool or laundry area.
Manufacturer is not liable for damages due to improper installation methods not followed herein or as required by national electrical or local
building code. > Installation Code Compliancy is the responsibility of user and or installer and not of the Manufacturer or it’s agents.
If you are not skilled with running wires through wall; it is strongly recommended that a qualified installation professional should install this
product.
This product does not have built-in electronic circuitry for surge protection or A/C filtering.
It is recommended that this product be connected to a quality surge-protector/power conditioner for equipment protection.
Limited 2-year Warranty from Manufactures Defects. HD-Products, Inc. the Manufacturer, it's agents, suppliers, and affiliates, shall not be liable for
damages, not limited to; misuse, acts of nature, verbal and written expression and improper installation. Improper installation is determined such to
include, not limited to, non-code compliant installation, product modifications, alterations, adjustments, and connections using non-code compliant
methods and or materials. Your TSPBIW has a limited two year product warranty against manufacturer’s defects. If you have any questions or
experience any problems with your product, please contact PowerBridge Customer Service .
Maximum claim liability not to exceed the product purchase price or Manufacturers Suggested Retail Price.
HD Products Inc. PowerBridge 3869 Norwood Drive Littleton, CO 80125 USA.
Customer Service: 303.683.2434 x4101 [email protected]. www.PowerBridge1.com