Rock-Slide Engineering 3rd BRAKE LIGHT KIT User Manual
Page 3
INSTALLATION INSTRUCTION RSEI 138
4. After the wires have become exposed through the end of the tire carrier, use 2
butt connectors to connect the black and white 2 pin connector to the end
5. Cut LED light grommet as needed to fit the center of spare tire hole
6. Install LED light grommet into the center of the spare tire hole
7. Attach black and white 2 pin connector to the back to the LED light
8. Push the LED light into the LED grommet to get a good connection
IMPORTANT: This is an LED light. It requires polarity to work. If you plug the LED light
into the grommet and it does not work, turn the light around and plug it in again.
Thank you for choosing Rock-Slide Engineering products. We value your business
and welcome your feedback/suggestions. If you have any concerns please contact
us directly @ 435-752-4580. We are here to help you!