Butler 645-071 - Manual (Page 16)

DECALCIFYING
The lime content of ordinary tap water
means limescale may gradually be
deposited inside the coffee maker. This
limescale may be loosened using acetic acid
(NOT ordinary vinegar) or descaler, available
in supermarkets etc.
1. Mix 100 ml acetic acid with 300 ml cold
water, or follow the instructions on the
descaler packaging.
2. Pour the solution into the reservoir and
switch on the coffee maker using the
on/off button.
3. Allow half of the solution to run through
the coffee maker, and then switch it off
using the on/off button.
4. Leave it switched off for around 10
minutes, and then switch it on again,
and allow the rest of the solution to run
right through.
5. To remove the final residues of limescale
and acetic acid, pour a potful of cold
water into the water reservoir, switch the
coffee maker on and allow the water to
pass through it.
6. Pass fresh water through the machine 3
times (as described in point 5). The
coffee maker is now ready for use again.
ENVIRONMENTAL TIP
An electronic appliance should, when it is no
longer capable of functioning, be disposed
of with least possible environmental damage
according to the local regulations in your
municipality. In most cases you can
discharge the appliance at your local
recycling centre.
THE WARRANTY DOES NOT COVER
- If the above points have not been
observed.
- If the appliance has not been properly
maintained, if force has been used
against it or if it has been damaged in
any other way.
- Errors or faults owing to defects in the
distribution system.
- If the appliance has been repaired or
modified or changed in any way or by
any person not properly authorised.
With reservations for printer's errors.
Owing to the constant development of our
products on both functionality and design
we reserve the right to change the product
without preceding notice.
IMPORTER:
Adexi group
We take reservations for printing errors.
16
IM 04/04/05 15:35 Side 16