J.P. Instruments EDM 760 Fuel Flow Installation Manual - Manual (Page 2)

J.P.Instruments Fuel Flow Installation Manual
Report # 760
for EDM-760 temperature indicating system with Fuel Flow Option Appendix - A
Page Page 2 of 14 Rev NC :
Date 07/20/99
EDM-760 with Fuel Flow Option
Installation Instructions
1…General:
A complete thorough familiarization and understanding of the system and this manual is necessary before
commencing the installation. All work must conform with A.C. 43.13.1A ch. 11 sec. 2, 3, 7. The accuracy of this
instrument depends entirely upon the accuracy of the data entered. A periodical checking of the actual fuel onboard
will eliminate the accumulation of errors due to evaporation leaks, etc.
Do not use the FXT-201 Flow Transducer on aircraft with a gravity feed system . The standard
Fuel Transducer (FXT-201) shipped with the EDM-760(),with Fuel Flow option Fuel Flow instrument is
intended to be used on aircraft equipped with fuel pumps.
Transducer Identification Markings
FXT-201 - Marked "20 l " on the top of the unit.
Installation of the EDM-760(), with Fuel Flow option on an aircraft with a fuel return line from the
Carburetor requires a FFDM-1 Differential Module .
The placard "Do Not Rely on Fuel Flow Instrument to Determine Fuel Levels in Tanks" must be
mounted on the aircraft instrument panel near the EDM-760, ( ) with fuel flow option.
If the aircraft is equipped with a primary fuel flow, the following placard must be mounted on the
aircraft instrument panel near the EDM-760(),WITH FUEL FLOW OPTION( ): "Refer to Original Fuel Flow
Instrumentation for Primary Information".