Security Chain Co (SCC) Quik Grip CAM Single - Manual (Page 2)

Cam side chain adjusters should be
closed by turning the cam clockwise
with the included cam tightening tool. If
there are more than 2 “loose” links at any
of the fasteners, we recommend that you
secure them to the side chain with a piece
of wire or a plastic tie.
Next fasten the outside fastener in
the same manner, again making
sure it is as tight as possible. Drive a
short distance and retighten all fasteners.
For best results, make sure fasteners are
adjusted equally and as tight as possible.
Reach behind the tire and fasten the
inside connector making sure it is as
tight as possible. See the illustration below for
a detailed look at this connection.
Drive forward a few feet, far enough
so that two or three of the cross
chains pass under the tire.
Drape the chain over the tire, so that
one cross chain is positioned at the
point where the tire meets the ground.
Again make sure the cross chain hooks are
facing upward. Hooks that face down
(towards the tire) will cause damage to the
tire. “CAM” side adjusters should be on the
outside of the tire.
Park vehicle on firm level ground,
and turn off the engine. Set the
parking brake. Lay the tire chains out flat
on the ground, making sure there are no
twists or tangles. Make sure the cross
chain hooks are facing upward.
Installation
Removal
Drive vehicle off highway to safe level ground. Turn off the
engine and set emergency brake. Loosen the cams and
unhook the outside fastener. Repeat procedure on inside fas-
tener. Lay the chains on the ground and drive vehicle off
chains. Inspect chains for damaged or worn parts. After use,
clean and spray with an all-purpose lubricant.
1 2 3
4 5 6
Close-up of outside & inside fastening system