Bu1300, U.k. and ireland – BIONAIRE BU1300 User Manual

Page 2

Advertising
background image

BU1300

Fig. 1

CONGRATULATIONS
By choosing a Bionaire

®

humidifier, you have chosen

one of the finest humidifiers on the market today

READ AND RETAIN THE FOLLOWING

FOR FUTURE REFERENCE.
IMPORTANT SAFEGUARDS
Please read this manual carefully before using
this appliance, as correct use will give you the
best possible performance.
When using electrical appliances, basic safety
precautions should always be followed, including
the following:

Read all instructions before using.

Close supervision is necessary when any
appliance is used near children. Appliance
must be kept out of the reach of children.

Appliance must be used by a responsible
adult.

Unplug from outlet when not in use, before
putting on or taking off parts, and before
cleaning.

Do not operate any appliance with a
damaged cord or plug, or after the appliance
malfunctions or has been dropped or
damaged in any manner. If the cord is
damaged, it must be replaced by the the
manufacturer or a service agent in order to
avoid hazard.

The use of accessory attachments not
recommended or sold by Bionaire

®

may

result in fire, electric shock or personal
injury.

Do not use outdoors.

Do not let cord hang over edge of table or
counter, or touch hot surface including the
stove.

Do not use appliance for other than intended
use.

Always disconnect the appliance from the
supply if it is left unattended and before
assembling, disassembling or cleaning.

In the event of a momentary electrical
disturbance, the product may malfunction
and require user to reset the product.

Check the operating voltage shown on the
back of the unit. Do not operate at higher
voltage than shown.

Never turn on, plug in or unplug the
humidifier while your hands are wet in order
to avoid electric shock.

Ensure humidifier is level. If the humidifier is
not level always turn the power off before

handling it.

Do not disassemble the humidifier while it is
plugged in to avoid electric shocks.

If you need to replace the plug or cable
always refer to the instructions.

Do not operate appliance with a damaged
cord or if the appliance has been dropped or
damaged. To avoid the risk of electric shock
never disassemble the appliance. Take
appliance to a qualified repair centre for
examination and repair. Incorrect re-assembly
can cause a risk of electric shock when
used.

If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person.

Do not place humidifier in front of ventilating
outlets and keep away from furniture and
other electrical appliances.

Do not add water directly into the mist
nozzle outlet.

Unplug the humidifier from the mains if it is
not to be used for any length of time.

Do not pour water into the mist nozzle outlet
while the humidifier is plugged into the
mains.

When the water tank is full the humidifier
can be used for 8 - 10 hours without refilling.

PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is disconnected from

the wall outlet and humidity control switch
(C) is in the off position ( ).

2. Remove the tank lid and fill with cool, fresh

tap water.

3. Replace the lid.
4. Place the water tank (E) on the base (D).
5. Ensure humidifier is level. If the humidifier is

not level always turn the power off before
handling it.

OPERATING INSTRUCTIONS
1. Plug the power cord into a convenient

electrical outlet.

2. Power/Night light (B) will illuminate when the

unit is operating. When the unit is out of
water or when the unit is switched off, the
Power/Night light will not be working.

3. Turn your humidifier on by rotating the

humidity control switch (C) to the high
position ( ) It will take a few minutes
before full moist air output is obtained.

4. Power/night light (B) will illuminate when

humidifier is connected to main electrical
power and the humidifier is switched on.

5. To reduce the speed at which the vapour is

U.K. and IRELAND

emitted, turn the humidity control switch
towards the low position ( ).

6. Rotate the humidity control switch from low

to high to regulate the mist output.

7. Rotate the mist nozzle (A) to the desired

mist direction.

8. When the unit runs out of water, the

transducer will automatically shut off.

9. Turn the humidity control switch anti-clockwise

to the off ( ) position, then unplug the
unit.

10. Before refilling the tank, empty any residual

water and follow the Daily maintenance
instructions.

11. Refill the water tank with cool tap water and

replace onto the base.

12. Plug power cord into the electrical outlet and

turn the humidty control switch clockwise to
the desired humidity level.

13. DO NOT move the humidifier with water in

the tank on the humidifier base. This may
cause the humidifier to function
intermittently, or stop emitting mist
altogether. Should this occur, simply remove
excess water from the humidifier base.

IMPORTANT: If you do not plan to use your
humidifier for two or more days, make sure any
residual water is drained from the tank and base
to prevent any bacteria growth in stagnant water.

CARE AND CLEANING
Humidifiers provide comfort by adding moisture
to dry, heated indoor air. To get the most benefit
from the humidifier and to avoid product misuse,
follow all instructions carefully, specifically the
operation, care and maintenance guidelines.
Please note this is an electrical appliance and
requires attention when in use.
Cleaning your humidifier every one or two
weeks, depending on the water conditions is
important in order to maintain efficient, healthy,
odour-free operation. Water quality varies
widely and, combined with build-up of mineral
scale in your humidifier, may under certain
conditions promote the growth of micro-organisms
in the water tank.
Before cleaning, Please note the

following:

DO NOT use soap, detergents, abrasives,
gasoline, glass or furniture polish, or boiling
water to clean any part of your Ultrasonic
Humidifier. These will interfere with the
proper operation of your unit and may affect
its appearance.

DO NOT use sharp or metal objects to clean
mineral deposits in the reservoir. Contact
with sharp objects can result in damage to
the plastic.

Mineral deposits should be soaked for up to
20 minutes in Bionaire

®

"Clean-Away"

solution or in plain vinegar and water to help
with their removal.

NEVER mix "Clean-Away" solution with any
other fluid!

DO NOT clean any part of your humidifier in
the dishwasher.

Daily maintenance:
1. Before cleaning, set the humidity control

switch to the Off position ( ) and unplug
the unit from the electrical outlet.

2. Lift off the tank of the humidifier.
3. Carry the base and the tank to the sink, then

drain and rinse the base and tank thoroughly
to remove any sediment or dirt. Wipe clean
and dry with a clean cloth or paper towel.

4. Refill the tank with cool tap water as

instructed in “Operating Instructions”. Do not
over fill.

5. If moisture forms on walls or window, turn

the humidifier off.

STORAGE TIPS
If you do not plan to use your unit for an
extended period of time, (i.e. during the summer
months), it is important that you follow these
instructions to help prevent stagnation of water
in the unit.
1. Turn the unit off and disconnect from the

outlet. Remove the water tank, then empty
the tank and the base completely. Clean the
humidifier as instructed in the cleaning
instruction section.

2. Dry the unit thoroughly. DO NOT leave any

water in the unit when storing.

3. Pack the humidifier in its original carton and

store in a cool, dry place.

A Mist Nozzle
B Power/Night Light
C Humidity Control Switch
D Base
E Water Tank

A

B

C

D

E

BU1300IUK05EM2 V.qxd 6/28/05 16:18 Page 4

Advertising