PHCC Pro Series Pro Series 1000 Battery Backup Sump Pump System (without silence switch) - Manual (Page 12)

REPLACING THE BATTERY
IMPORTANT: REVIEW THE
SAFETY INSTRUCTIONS
BEFORE YOU PROCEED
1. Unplug the charger from the wall
outlet.
2. Remove the battery cables from the
battery posts.
3. Fill the battery following the instruc-
tions on page 7.
4. Coat the battery terminals with a
little petroleum jelly and replace the
battery cables, BLACK to the
POSITIVE (+), post and WHITE to
the NEGATIVE (-) post. Tighten the
wing nuts. Replace the battery cap
in the cell which is 2nd from the
POSITIVE post with the yellow cap
from the old battery. Insert the fluid
sensor in the cap.
5. Plug the charger into the wall outlet.
6. You may have to press the reset
button to silence the pumping alarm.
TEST BUTTON
The TEST button may be used to check
the pump and system. Push the TEST
button. This will activate the pump for as
long as you hold the button.
TESTING THE FLOAT SWITCH
Manually testing the float switch
periodically is highly recommended.
Lift the float up and let go.
This will
activate the pump. The control unit will
run the pump for approximately 40
seconds so it can empty all the water in
the sump pit. If there is no water in the
sump, the pump can run dry for this
amount of time. The alarm will sound
and the pump light will go on. After the
pump has stopped, push the gray button
to silence the alarm. If the gray RESET
button is pressed before the pump has
stopped, the alarm will go off tem-
porarily.
Wait for the pump to stop
pumping, and then push the RESET
button to completely silence the alarm.
PARTS & SERVICE INFORMATION
You can receive technical support, parts
or service information by calling
Glentronics, Inc. at (800) 991-0466,
option 3.
Send your unit to the following address
for repairs:
Glentronics, Inc.
640 Heathrow Dr.
Lincolnshire, IL 60069
Page 11
3
1
2
4
5
6
Glentronics, Inc., 640 Heathrow Dr., Lincolnshire, IL 60069
800-991-0466
©2001, Glentronics, Inc.
LIFT
FLOAT
1806013