AEM 25-108BK High Volume Fuel Rail User Manual
Page 7
5) Final Assembly and Inspection
a) Connect the negative battery terminal.
b) Turn the ignition switch to the on position for approximately two seconds and then turn the ignition
switch to the off position. Do not operate the starter.
i)
Repeat this procedure three times, and then check all components that were removed during
installation for any signs of fuel leakage.
ii) Check the area around the fuel inlet fitting, the –6 plug and the 1/8” NPT plug. If these
three items were not installed correctly then they may be prone to leak.
iii) If there are signs of leakage you MUST correct the leak before proceeding.
c) If there are no signs of leakage, then start engine and again check for leaks.
d) If there are no signs of leakage on your final inspection, then the installation is complete.
For Technical Inquiries
E-Mail Us At