AEM 30-2067 X-WiFi K-Type Closed Tip Thermocouple Kit - Manual

INSTALLATION
1. Disconnect the negative battery cable.
2.
Using the supplied Stainless Steel 1/8”NPT compression mount, mount the EGT
thermocouple as shown in Figure 2. Common locations for mounting the EGT
thermocouple are 1-2 inches from the exhaust port, 2-3 inches before the turbine
inlet, or in the header collector.
3. Connect the EGT thermocouple to the extension harness as shown in Figure 3.
4. Connect the 3-pin connector on the thermocouple extension harness to either the
EGT 1 location or EGT 2 location as shown above in Figure 1.
When using both thermocouples for comparison (bank 1 EGT and bank 2 EGT for
example), make sure to mount both thermocouples in a similar fashion (distance from
port, tip depth, tube diameter, etc) so the readings are not influenced by installation
differences.
AEM Performance Electronics
2205 126 th Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aemelectronics.com
Instruction Part Number: 10-2320 Rev 01

2009 AEM Performance Electronics
AEM X-WIFI EGT Connection Guide
Figure 1. Wiring Schematic