AEM 30-2355-XXX No-Weld O2 Sensor Mount - Manual (Page 3)

3
Step 1 Step 2
Step 3 Step 4
Gasket applied to tube
3. Open the clamp band and position the O2 fitting over the hole and ensure the boss inserts into the hole.
Assemble the end blocks, center block, bolts washers and nuts as shown in the diagram. Please note;
on 2.25”, 2.75” & 3.25” pipes the center block is not used. Tighten the nuts evenly until you
achieve 10 lbs./ft. torque.
4. Install your O2 sensor into the fitting taking care not to damage the tip of the sensor. When tightening
the O2 sensor into the No-Weld O2 Sensor Mount, be sure to hold the 1” (25mm) hex fitting in place
with a second wrench so it does not slip or have any twisting forces placed on it.