AEM 30-2906-96 AQ-1 96 Flying Lead Wiring Harness - Manual (Page 5)

Page 5 10-2906-96 AQ1 Harness Instructions RevA 110906.doc
CAN BUS 2
Not used with AQ1 Data Logger PN 30-2500
USB
The AQ1 Data Logger has two USB ports for easy connection and programming. The
AQ1 Data Logger receives low voltage power from the USB port, allowing users to
access the SD card and make configuration changes at all times, 12 volt power is not
necessary. The black remote mount USB port in the harness is designed for easy in
vehicle programming and data downloads. The USB port on the back of the enclosure
allows for easy bench top programming and data downloads when the module is
removed from the vehicle. See Figure 5 below.
Figure 4. Typical GPS Connection
Figure 5. AQ1 On-Board (Left) and Harness (Right) USB Ports