AEM 30-3255 Engine Position Module User Manual
Page 3
Advertising
c) Install the special slotted Disc into the EPM with the chamfered side in. Disc can
be rotated to align with the different mounting holes for the B, D, and H series
engines (see figure 3).
Figure 3.
d) Lubricate the O-ring with clean motor oil and install the EPM onto the engine.
Orientate The EPM as shown in figure 4 and secure with the existing Honda bolt
and washer. The other two distributor mounting bolts are not required.
Figure 4.
3) EPM Wiring
a) The EPM has a short cable with a 4 pin connector, supplied with the EPM is the
mating connector housing with 5 crimp terminals. The connector pinouts are
shown in figure 5.
Page 3 of 5
Advertising