AEM 30-3421 Analog Gauge Wiring Conversion - Manual

This harness allows users to switch from digital style wideband gauges to
analog style wideband gauges without rewiring the gauge and sensor.
Remove the sensor and power harnesses from the back of the digital
gauge. Plug the digital gauge power harness into the mating connector on
the adapter harness. See Figure 1 below. Plug the adapter harness and
sensor harness connectors into the mating connectors on the back of the
analog gauge.
AEM Performance Electronics
2205 126 th Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aemelectronics.com
Instruction Part Number: 10-3421 Rev 01
© 2010 AEM Performance Electronics
Part Number 30-3421
Digital to Analog Style Wideband Gauge Adapter
Harness
Figure 1. Adapter Harness Connected to Digital UEGO Power Harness
Use this adapter harness when converting from the following
digital gauges to analog gauges
Gauge Digital Analog
Wideband AFR 30-4100 30-5130, 30-5143