AEM 30-3420 Analog Gauge Wiring Conversion User Manual
AEM For the car
This harness allows users to switch from digital style display gauges to
analog style display gauges without rewiring the gauge and sensor.
Remove the harness from the back of the digital gauge. Plug the digital
gauge harness into the mating connector on the adapter harness. See
Figure 1 below. Plug the remaining connectors on the adapter harness into
the mating connectors on the back of the analog style gauge.
AEM Performance Electronics
2205 126
th
Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aemelectronics.com
Instruction Part Number: 10-3420 Rev 01
© 2010 AEM Performance Electronics
Part Number 30-3420
Digital to Analog Style Gauge Adapter Harness
Figure 1. Adapter Harness Connected to Digital Gauge Harness
Use this adapter harness when converting from the following
digital gauges to analog gauges
Gauge Digital
Analog
Battery Volts
30-4400
30-5139
Pressure, 100 PSI
30-4401
30-5133(M)
Fluid Temperature
30-4402
30-5140(M)
Boost/Vac 35 PSI
30-4406
30-5132(M)
Pressure, 150 PSI
30-4407
30-5135(M)