AEM 30-3509 Infinity Plug & Play Harnesses - Honda/Acura OBD2B User Manual
Page 5
1999–2001 Honda B-H-D Series OBD2b
5
© 2014 AEM Performance Electronics
The gray Deutsch 4P DTM connector is used for “AEMNET”. AEMNet is an open architecture based on
CAN 2.0 which provides the ability for multiple enabled devices, such as dashboards, data loggers, etc.,
to easily communicate with one another through two twisted cables (CAN+/CAN-).
The black Delphi 2-pin “FLASH” connector is used for secondary hardware flashing. The included shunt
connector jumps the 2 wires together. Once initially flashed, the EMS is normally upgraded in the
software, not using this connector.
The gray Deutsch 12P DTM “AUX” connector is used
to adapt many common ancillary inputs and outputs
easily. Included in the kit are a DTM 12P mating
connector, 12 DTM terminals, and a DTM 12P
wedgelock. If used, these components will need to be
terminated by the installer or end user with 16
–
22awg
wire (not included). Note: The pin numbering is
molded into the connector, as shown.