Overview, Getting started, Downloadable files – AEM 30-3510 Infinity Plug & Play Harnesses - BMW 2001-2006 E46 M3 User Manual
Page 2
2
© 2014 AEM Performance Electronics
P/N 30-3510
OVERVIEW
The 30-3510 AEM Infinity Adapter Kit was designed for the 2001–2006 BMW E46 M3 with manual
transmission. This is a true standalone system that eliminates the use of the factory BMW DME (ECU).
The use of this adapter makes the kit “plug and play” so no cutting or splicing wires is necessary. The
base configuration files available for the Infinity EMS are starting points only and will need to be modified
for every specific application. Included in these instructions are descriptions of important differences
between using the factory BMW DME and using the AEM Infinity ECU.
The available AEM Infinity EMS part numbers for this adapter kit are:
30-7109 INFINITY-8
30-7105 INFINITY-10
NOTE: The Infinity-10 EMS has 2 extra ignition coil and injector outputs for a total of 10 each. These are
sold separately from this adapter kit.
INFORMATION ON INFINITY ECUS USED ON 2005–06 BMW E46 M3’S EQUIPPED WITH FACTORY
COMPETITION PACKAGE:
When the Infinity is used on 2005–06 model year E46 M3s, the DSC lamp will remain illuminated when
the key is in the “on” position. Certain CAN bus features of the Infinity are not available via the steering
wheel cruise control buttons, as these vehicles did not come with factory cruise control buttons. (The
features integrated through CAN bus can be added using an ancillary trim position switch.)
GETTING STARTED
Refer to the 10-7100 for EMS 30-7100 Infinity Quick Start Guide for additional information on getting
the engine started with the Infinity EMS. E46 BMW M3 base session is located in C:\Documents\AEM
\Infinity Tuner\Sessions\Base Sessions
DOWNLOADABLE FILES
Files can be downloaded from
. An experienced tuner must be available to configure
and manipulate the data before driving can commence. The Quick Start Guide and Full Manual describe
the steps for logging in and registering at
These documents are available for
download in the Support section of the AEM Electronics website:
Downloadable files for 2001–2006 BMW E46 M3
7105-XXXX-64 Infinity-10 BMW E46
(XXXX = serial number)
7109-XXXX-65 Infinity-8 BMW E46
(XXXX = serial number)
NOTE: The Flash Enable connector (described in the following pages) MUST be “jumped” in
order to connect to the Infinity and load the initial firmware file. Subsequent firmware
upgrades will not require this step.
Ignition key OFF
Insert zip-tied jumper shunt connector into Flash Enable connector
Ignition key ON (RUN position)
Infinity Tuner | Target | Upgrade Firmware… | Upload downloaded .pakgrp file
Disconnect Flash Enable jumper connector
Infinity Tuner | File | Import Calibration Data | Select appropriate base session file